Need help?Do you have a question about the Yaesu FT-818ND and is the answer not in the manual?
General| Power Output | 6W |
|---|---|
| Antenna Impedance | 50 Ohms |
| Dimensions | 135 x 38 x 165 mm |
| Antenna Connector | SO-239 |
| Modes | SSB, CW, AM, FM |
| Supply Voltage | 13.8V DC ±15% |
| Weight | 1.2 kg |
| Receiver System | Double conversion superheterodyne |
| Selectivity | FM: 12 kHz (-6 dB) |
| Current Consumption | RX: 450 mA |
Instructions for connecting the primary antenna.
How to connect the microphone.
Guide for installing and using AA alkaline batteries.
How to connect an external DC power source.
Guide for installing and using the Ni-MH battery pack.
Connects the hand microphone.
DC power supply connection and battery charging input.
Connects to TNC or computer for digital modes.
Connects to external accessories or computer for cloning.
Connects HF/50 MHz antenna.
Procedure for powering the transceiver on and off.
How to select the operating frequency band.
How to select the operating mode (LSB, USB, CW, etc.).
How to adjust RF Gain and Squelch controls.
How to set the operating frequency using controls.
Adjusts receive frequency offset for tuning.
Basic setup and operation for SSB mode.
How to select power levels for transmission.
Automatic transmit/receive switching via voice.
Operation using straight key or external keyer.
Using the transceiver's internal electronic keyer.
Basic setup and operation for FM mode.
How to operate through repeaters.
Overview of digital mode capabilities.
Specific instructions for RTTY operation.
Specific instructions for PSK31 operation.
Custom digital mode configurations.
Instructions for packet radio operation.
How to initiate and control band scanning.
Resets memories & specific menu settings.
Resets most menu settings to factory default.
Performs a CPU master reset for all settings.
General technical specifications of the transceiver.
Transmitter-specific technical specifications.
Receiver-specific technical specifications.
To Next Page
