What to do if the red transmit LED turns on and the Yaesu FTA-230 Transceiver cannot be operated after connecting the CT-96 headset cable?
If the red transmit LED on your Yaesu Transceiver turns on and the radio becomes inoperable after connecting the CT-96 headset cable, ensure that the CT-96 connector is fully screwed into the MIC/EAR jack. Simply pushing it in is not enough to establish proper contact within the radio.
General| Brand | Yaesu |
|---|---|
| Model | FTA-230 |
| Category | Transceiver |
| Language | English |
Details FCC RF exposure limits and compliance for occupational use.
Lists safety precautions and provides a guide for battery handling.
Provides notes on charger use and explains the low battery indicator.
Guides through initial setup and quick operation of the transceiver.
Details methods for selecting frequencies and adjusting audio volume.
Covers squelch adjustment, emergency frequency access, and transmission.
Details the different methods for tuning and selecting frequencies.
Provides instructions for activating and configuring the VOX system.
Explains how to recall and view stored memory channels.
Guides on how to start and control automatic scanning in various modes.
Explains how to activate and utilize the Dual Watch feature.
Guides on activating and setting up the Priority Dual Watch feature.
Details programming a transmit frequency and operating in split mode.
Details the process to reset the microprocessor to factory default settings.
Provides answers to common questions and solutions for operational issues.
To Next Page
