Need help?Do you have a question about the Yaesu G-2800DXA and is the answer not in the manual?
Discusses dangers of tower installation, lightning strike risks, and recommends precautions.
Details limitations for pole-mounted antennas based on wind load area and mast length.
Explains the K factor calculation for tower-mounted antennas and provides an example.
Step-by-step guide for preparing the control cable for G-800DXA and G-1000DXA models.
Guide on connecting the cable to the rotator and controller, and performing initial tests.
Illustrates the wiring diagram for connecting the control cable between the rotator and controller.
Procedures for calibrating the azimuth indicator needle alignment and range.
Verifying automatic rotation stops and calibrating PRESET ADJ A and B potentiometers.
Details on drilling a 9 mm hole in the mast for the anti-twist support bolt.
Procedures for attaching the antenna mast to the rotator using mast clamps.
Installing the rotator control cable's plug and securing it with the boot and tape.
Details on drilling a 9 mm hole in the mast for the anti-twist support bolt.
Procedures for attaching the antenna mast to the G-2800DXA rotator using mast clamps.
Installing the G-2800DXA control cable's plug and securing it with the boot and tape.
A comparative table detailing specifications for all three rotator models.
Discusses dangers of tower installation, lightning strike risks, and recommends precautions.
Details limitations for pole-mounted antennas based on wind load area and mast length.
Explains the K factor calculation for tower-mounted antennas and provides an example.
Step-by-step guide for preparing the control cable for G-800DXA and G-1000DXA models.
Guide on connecting the cable to the rotator and controller, and performing initial tests.
Illustrates the wiring diagram for connecting the control cable between the rotator and controller.
Procedures for calibrating the azimuth indicator needle alignment and range.
Verifying automatic rotation stops and calibrating PRESET ADJ A and B potentiometers.
Details on drilling a 9 mm hole in the mast for the anti-twist support bolt.
Procedures for attaching the antenna mast to the rotator using mast clamps.
Installing the rotator control cable's plug and securing it with the boot and tape.
Details on drilling a 9 mm hole in the mast for the anti-twist support bolt.
Procedures for attaching the antenna mast to the G-2800DXA rotator using mast clamps.
Installing the G-2800DXA control cable's plug and securing it with the boot and tape.
A comparative table detailing specifications for all three rotator models.
General| Frequency Range | Not applicable |
|---|---|
| Output Power | Not applicable |
| Modulation | Not applicable |
| Power Supply (Radio) | Not applicable |
| Weight (Radio) | Not applicable |
| Type | Rotator |
| Compatibility | Yaesu G-2800DXA compatible antennas |
| Control Method | Manual |
| Power Supply (Controller) | AC 120V |
| Rotation Range | 360° |
To Next Page
