Yaesu VX-6 - Page 86

112 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

VX-6R OPERATING MANUAL84

MISCELLANEOUS SETTINGS

NOTE

Table of Contents

Table of Contents2
General Description3
Accessories & Options4
Controls & Connections5
- Top & Front Panel5
- Lcd5
- Keypad5
- Power Switch5
- Side & Bottom Panel7
Installation of Accessories10
- Antenna Installation10
- Belt Clip & Hand Strap Installation10
- Installation of FNB-80LI Battery Pack11
- Battery Charging11
- Installation of FBA-23 Battery Case12
- Low Battery Indication12
Interface of Packet Tncs13
Operation14
- Switching Power on and off14
- Adjusting the Volume Level14
- Squelch Adjustment15
- Selecting the Operating Band16
- Frequency Navigation16
- Transmission18
  - Changing the Transmitter Power Level19
  - Changing the Microphone Gain Level20
- AM Broadcast Reception20
- AM Aircraft Reception21
- FM Broadcast/Tv Audio Reception21
Advanced Operation22
- Keyboard Locking22
- Adjusting the Keypad Beeper Volume Level23
- Keypad/Lcd Illumination23
- Changing the Channel Steps24
- Changing the Receiving Mode24
- RF Squelch25
- Checking the Battery Voltage25
Repeater Operation26
- Repeater Shifts26
- Automatic Repeater Shift (ARS)26
- Manual Repeater Shift Activation27
- Tone Calling (1750 Hz)28
- Checking the Repeater Uplink (Input) Frequency28
CTCSS/DCS Operation29
- CTCSS Operation29
- DCS Operation30
- DCS Code Inversion31
- CTCSS/DCS Bell Operation32
- Tone Search Scanning33
- Split Tone Operation34
Memory Mode35
- Memory Storage36
- Storing Independent Transmit Frequencies ("Odd Split")36
- Memory Recall37
- Labeling Memories37
- Memory Offset Tuning39
- Moving Memory Data to the VFO40
- Masking Memories40
- Memory Only Mode40
- HOME Channel Memory41
- Memory Bank Operation42
  - Assigning Memories to a Memory Bank42
  - Memory Bank Recall42
- Direct Memory Recall Channel44
- Short-Wave Broadcast Station Memory Channels45
- Weather Broadcast Channels46
- VHF-Marine Channels47
Scanning48
- VFO Scanning49
  - Setting the Squelch Level During Activate Scanning Opertion50
  - How to Skip (Omit) a Frequency During VFO Scan50
- Memory Scanning51
- Programmable (Band Limit) Memory Scan (PMS)54
- Priority Channel" Scanning (Dual Watch)55
- Automatic Lamp Illumination on Scan Stop56
- Band Edge Beeper56
- Weather Alert Scan57
Smart Search Operation58
Channel Counter Operation60
EPCS (Enhanced Paging & Code Squelch)62
- Storing the CTCSS Tone Pairs for EPCS Operation62
- Activating the Enhanced Paging & Code Squelch System63
- Paging Answer Back63
Emergency Feature64
- Emergency Channel Operation64
- Emergency Automatic ID Eai Feature64
Basic Arts Setup and Operation67
ARTS (Automatic Range Transponder System)67
Cw Identifier Setup69
Sensor Mode70
- To Display the Temperature70
- To Display the Sensor Information70
- Selecting and Correcting the Atmospheric Pressure Meter71
- Selecting and Correcting the Altimeter71
SRG ("Sister Radio Group") Mode72
Internet Connection Feature72
FRG ("Friendly Radio Group") Mode73
DTMF Operation75
- Manual DTMF Tone Generation75
- DTNF Autodialer75
- Dtmf Autodialer75
CW Training Feature77
Miscellaneous Settings78
- Password78
- Programming the "P" Key79
- Receive Battery Saver Setup79
- Wakeup Feature Setup80
- TX Battery Saver81
- ATT (Front End Attenuator)81
- Disabling the TX/BUSY Indicator82
- Automatic Power-Off (APO) Feature82
- Automatic Power-On Feature83
- Busy Channel Lock-Out (BCLO)84
- Transmitter Time-Out Timer (TOT)85
- Changing the TX Deviation Level85
Reset Procedures87
Cloning88
Set (Menu) Mode89
Specifications106
AUTO" Mode Preset Operating Parameters108
Installation of the SU-1 (Option)109
FCC Notice110
Declaration of Conformity111

Related product manuals

Preview: Yaesu VX-6R

Preview: Yaesu VX-7R

Preview: Yaesu VX-8R

Preview: Yaesu VX-1R

Preview: Yaesu VX-3R

Preview: Yaesu VX-5R

Preview: Yaesu VX-2R

Preview: Yaesu VX-8DR

Preview: Yaesu VX-170

Preview: Yaesu VX-177

Preview: Yaesu VX-8GR