16 CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE
Reference
Performances
Editing Performances
Common Edit Area
01: Chorus Effect
02: Reverb Effect
03: General
04: Name
Part Edit Area
01: Play Mode
02: Filter/EG
03: Effect-A
04: Effect-B
05: Controller
06: Receive Switch
Master Keyboard Area
Job Area
01: Recall
02: Copy
03: Bulk
Store Performance Function
Compare Performance Function
File Area
01: Save
02: Load
03: Rename
04: Delete
05: Format
06: Memory Info
Utility Area
01: General
02: MIDI
03: Controller
04: MasterComp
05: Master EQ
06: Panel Lock
Utility Job Area
01: Factory Set
02: Version
Appendix
Part Edit Area
NOTE On the CP40 STAGE, the same Part is selected by pressing either the [LAYER] or [SPLIT] button with the
[PART SELECT] button held down.
NOTE The Edit menu is the first screen displayed when the [EDIT] button is pressed.
The following screenshots illustrate how, for example, to edit parameters on the Play Mode screen.
02: Part selected in Step 4:
Parameter type selected in Step 5:
Parameter setting screen from Step 6:
1 EDIT Part: (Current Part)
This shows that you are on the Part Edit menu. The name of the Part selected for editing is shown
after the colon (:).
CP4 STAGE: MAIN, LAYER, or SPLIT
CP40 STAGE: MAIN or SP/LA
2 More symbol
This symbol indicates that other menu items are available for selection. In this case, the next one
can be displayed by pressing the [d] button.
3 Menu item
The items available for selection from the Part Edit menu are shown here. Select the required item
(01 to 06) using the [d] and [u] buttons, and then press the [ENTER] button to display the editing
screen for the corresponding parameters.
4 Selected screen
The name of the current screen is shown here.
Procedure 1. Turn on the Part you wish to edit using the corresponding button.
2. Hold down the [PART SELECT] button and press the Part button from Step 1 once again to
select the Part for editing.
3. Press the [EDIT] button.
4. On the Edit menu, use the [d] and [u] buttons to select 02: Part, and then press the [ENTER]
button.
5. Using the [d] and [u] buttons, select the type of parameter you wish to edit (01 to 06), and
then press the [ENTER] button.
6. Make the required changes to parameter settings on the corresponding screen.
EDIT
W02:Part
E
Press the [ENTER] button.
EDIT Part:MAIN
D01:PlayMode
E
1
23
Press the [ENTER] button.
Part:MAIN Volume
PlayMode 115
Pan Gain E
R20 R100D
8
7
94 6
5
To Next Page
Loading...
Need help?
General