47 CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE
Reference
Performances
Editing Performances
Common Edit Area
01: Chorus Effect
02: Reverb Effect
03: General
04: Name
Part Edit Area
01: Play Mode
02: Filter/EG
03: Effect-A
04: Effect-B
05: Controller
06: Receive Switch
Master Keyboard Area
Job Area
01: Recall
02: Copy
03: Bulk
Store Performance Function
Compare Performance Function
File Area
01: Save
02: Load
03: Rename
04: Delete
05: Format
06: Memory Info
Utility Area
01: General
02: MIDI
03: Controller
04: MasterComp
05: Master EQ
06: Panel Lock
Utility Job Area
01: Factory Set
02: Version
Appendix
06: Panel Lock
Using the [PANEL LOCK] button, you can lock your stage piano’s buttons, Part sliders, and other
controllers in order to avoid operating them by mistake while playing. On the Panel Lock screen,
you can set each of the following parameters to “off” to prevent the [PANEL LOCK] button from
locking the corresponding controllers.
NOTE By default, all controllers except the following can be locked: [PANEL LOCK] button, [SHIFT] button,
[EXIT] button, MASTER EQ sliders, [MASTER VOLUME] dial, keyboard, pitch bend wheel, modulation
wheel, foot switch, and Foot Controllers 1 and 2 (CP4 STAGE) or foot controller (CP40 STAGE).
Parameter name Description
Part
(Panel Lock: Parts)
This parameter can be used to enable (“on”) or disable (“off”) locking of the
Part-related controllers shown below.
Settings: off and on
NOTE This setting applies to all of the following controllers; individual settings are
not supported.
Controllers affected: [MAIN], [LAYER], and [SPLIT] buttons; [PART SELECT]
button; [SLIDER FUNCTION] button; and Part sliders
Audio
(Panel Lock: Audio)
This parameter can be used to enable (“on”) or disable (“off”) locking of the
audio recording and playback controllers shown below.
Settings: off and on
NOTE This setting applies to all of the following controllers; individual settings are
not supported.
Controllers affected: [J] (Stop), [R] (Play), and [I] (Record) buttons
Effect
(Panel Lock: Effects)
This parameter can be used to enable (“on”) or disable (“off”) locking of the
effect-related controllers shown below.
Settings: off and on
NOTE This setting applies to all of the following controllers; individual settings are
not supported.
Controllers affected: [CHORUS] and [REVERB] SYSTEM EFFECT buttons;
[MASTER COMP] button; and [A] and [B] PART EFFECT buttons
Trnsps
(Panel Lock:
Transpose)
This parameter can be used to enable (“on”) or disable (“off”) locking of the
[-] and [+] TRANSPOSE buttons.
Settings: off and on
VceSel
(Panel Lock: Voice
Select)
This parameter can be used to enable (“on”) or disable (“off”) locking of the
Voice-selection controllers shown below.
Settings: off and on
NOTE This setting applies to all of the following controllers; individual settings are
not supported.
Controllers affected: [-1/NO] and [+1/YES] buttons; [u]/[d]/[l]/[r]
(Cursor) buttons; Voice Category buttons; and Data Dial
NOTE
When this parameter is set to “off”, you will be able to use the [-1/NO] and
[+1/YES] buttons, the [
u]/[d]/[l]/[r
] (Cursor) buttons, and the Data Dial on the
Performance screen only.
To Next Page