BLOCKHEAD
Part #1032037 Rev A
Set the bicycle forks
onto the skewer.
Align block
with drilled
holes.
Use the template below to
scribe two drilling points.
• Use 1/4"
(6mm)
mounting
hardware.
• Always check handlebar
clearance before attaching
block.
Pivot the bolts or
screws into place.
TEMPLATE
Tighten hardware
securely.
Test installation by
pulling and shaking.
Replace skewer
and attach the nut.
DRILL
POINT
DRILL
POINT
Test security by tugging at forks. If forks can move out of the
skewer, open lever and tighten the nut slightly.
Close lever again
with firm pressure. Repeat if necessary.
Yakima accepts no responsibility for improper installation.
Periodically check
the attachment
hardware and
tighten if needed.
Lubricate skewer
occasionally.
With lever open, tighten nut until the lever
closes with some resistance.
Loosen or tighten
the nut as needed
so that lever
closes with some
resistance.
Remove the skewer
from the block by
loosening the nut.
BlockHead attaches
securely to flat surfaces.
Recommended Mounting Hardware
includes 1/4" (6mm) bolts or screws,
fender washers, and locking nuts.
To Next Page
Need help?
General
