17
Command Class Firmware Update Meta Data, Version 5*
* This command class requires security.
Yale Z-Wave Plus ™ locks support over-the-air (OTA) upgrading of 2 firmware
targets:
1. Firmware Target 0: Z-Wave
™
chip
2. Firmware Target 1: The lock main processor
Firmware Target 0 is used to determine the correct Z-Wave
™
processor image to
download. ID 1 is always 0xA5, to signal this is an ASSA ABLOY Z-Wave
™
image,
and ID 2 is specific to the region, with the lower nibble being 0x0 and the upper
nibble being the value in Table 4 - Region-Specific Values for Firmware ID 0.
Eventually the lower nibble will be used to separate builds within a specific region,
but this will also be 0 for now, since there is only a single build of firmware.
Table 4 - Region-Specific Values for Firmware ID 0 (Upper Nibble)
Firmware 1 target will depend on which version of the lock is in use (mapped to the
Product Type ID).
• For YRC/D216-ZW3 (Push Button interface), Firmware 1 ID = 0x8004.
• For YRC/D226-ZW3 & YRC/D256-ZW3 (Touch Screen interface), Firmware 1
ID = 0x8002.
• For YRC/D652-ZW3 & NF-YRC/D622-ZW3 (2
nd
Generation Touch Screen
interface), Firmware 1 ID = 0x8109.
• For NF-YRC/D612-ZW3 (2
nd
Generation Push Button interface), Firmware 1
ID = 0x810A.
• For YRC/D622-ZW3 & YRC/D642-ZW3 (2nd Generation Fire Rated Touch
Screen Deadbolt), Firmware 1 ID = 0x8103
• For YRD410-ZW3, YRD420-ZW3, YRD430-ZW3 & YRD450-ZW3 (2nd
Generation Assure Deadbolt), Firmware 1 ID = 0x8104
To Next Page
Loading...
