19
a
tamper alarm when the system is disarmed. To
enable the display to be cleared a tamper condition
has to be rectified. For example, if a detector has
been tampered the display can only be cleared
once the detector tamper has been closed. The
display is cleared by entering your PIN code,
pressing OK, and exiting the Arm Home display by
pressing .
Please note that detector tampers will trigger an
alarm even when the system is disarmed. If you
wish to take down a detector that has tamper
protection ensure the control unit is in Walk Test
mode.
Low battery display
When a detectors batteries are running low, it will
s
ignal its condition to the control unit when it is
activated. To be able to clear the display the
batteries in the detector will have to be changed.
Always use alkaline batteries as replacements and
ensure the control unit is in Walk Test when taking
down detectors. After changing batteries, once the
detector is activated (out of Walk Test mode), the
display can be cleared as described in Tamper
display.
To Next Page
Loading...
