Table 9030-03-2. Node 30 Status Codes (Continued)
NODE STATUS DESCRIPTION
30 083 The Traction Controller has detected temperatures above controllers operating range.
30 086 The Traction Controller has detected Low DC Bus Voltage or a fault in the DC Bus circuit.
30 087 The Traction Controller has detected High DC Bus Voltage or a fault in the DC Bus circuit.
30 090 The Traction Controller has detected a fault in the 5 volt/12 volt output supply.
30 106 The Tiller Card is not communicating on the CANbus.
30 201 The Traction Controller has detected a Throttle release fault.
30 227 The Traction Controller has detected that the traction motor has stalled.
30 231 The Traction Controller has set the maintenance reminder.
30 232 The Traction Controller has detected software update request.
30 247 The Traction Controller has detected parameter update request.
30 248 The Traction Controller has detected temperatures below controller operating range.
*The Traction Controller and Tiller Control Card can detect an internal fault and is capable of reporting a
099 Status Code. Refer to the XX099 Status Code troubleshooting procedures for all Internal Fault Codes
regardless of what Node has reported the fault.
Table 9030-03-3. Node 60 Status Codes
NODE STATUS DESCRIPTION
60 050 The Tiller Control Card has detected a Belly Switch Mismatch fault.
60 210 The Tiller Control Card has detected a Belly Switch release fault.
60 211 The Tiller Control Card has detected a Tiller Arm release fault.
ELECTRICAL SYSTEM General Maintenance and Diagnostic Data
Check the Service Manual section in Yale Axcess Online for possible updates and check pertinent Bulletins
Confidential/Proprietary - Do Not Copy or Duplicate 9030-03-13
To Next Page
Loading...
