8
Install Range Hood
1 Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
A
B
C
A.Mountingscrews
B. Mounting slots
C. Lower mounting screws
1
2 Mark with a pencil the lower mounting holes location.
3 Uninstallthehoodassembly,anddrill3⁄16”(4.8mm)pilot
holes at marked locations.
4 Hang the range hood again on 2 upper mounting screws.
5 Level the range hood and tighten upper mounting screws.
6 Install 2 - 5 x 45 mm lower mounting screws and tighten.
Use the optional wall anchors if needed.
Connect Vent System
1 Installtransitionontopofhood(ifremovedforshipping)with
2-3.5x9.5mmsheetmetalscrews.
A
B
A.Venttransition
B.3.5x9.5mmscrew
For vented installations only:
1 Fit vent system over the exhaust outlet.
2 Measurefromthebottomoftheairdeectortothebottomof
the hood outlet. Cut the ductwork at the measured dimension.
Dimension
to measure
Roof outlet
Wall
outlet
3 Seal connection with clamps.
4 Check that back draft dampers work properly.
Electrical Connection
WARNING
ELECTRICALSHOCKHAZARD.
WARNING
DISCONNECTPOWERBEFORESERVICING.
REPLACEALLPARTSANDPANELSBEFOREOPERATING.
FAILURETODOSOCANRESULTINDEATHOR
ELECTRICALSHOCK.
1 Disconnect power.
2 Remove terminal box cover.
3 Remove the knockout in the terminal box cover and install
aULlistedorCSAapproved1⁄2”strainrelief.
4 Run home power supply cable through strain relief, into
terminal box.
A
B
C
D
E
A.Homepowersupplycable
B.ULlistedorCSAapprovedstrain
relief
C. Black wires
D. UL listed wire connectors
E. White wires
F.Green(orbare)andyellow-greenground
wires
5 Use UL listed wire connectors and connect black wires
(C)together.
6 UseULlistedwireconnectorsandconnectwhitewires(E)
together.
WARNING
ELECTRICALSHOCKHAZARD.