13
5. Using the system
Tamper alarm warning
If any device tamper switches are disturbed a tamper
alarm will be activated with the Siren sounding and the
strobe flashing. The alarm can be silenced as follows:
Silencing the Siren
Keypad: Press disarm followed by your PIN code.
(The Siren will be silenced and
then beep and flash twice.)
4
Press
PIN ****
x 2
If there is a persistent Siren tamper fault then a series
of 5 beeps and flashes will be given when the system
is armed, then the Siren should be checked for any
mounting problems and if the Siren lid is secure.
i
Previous alarm warning
Should there be an alarm that was triggered and expired
(while the user was away), the Siren will sound and flash
for 3 seconds after disarming (user returning home).
3secs
Alarm Function Modes
Entering setting mode:
Using the Keypad, press Panic button A followed by PIN code
(factory default is 0000). You can now select different functions.
(The LED on the Keypad will start flashing)
Function setting:
Press Panic button A, followed by one of the following number key:
1 Send learning/testing signal
2 Disable Siren tamper
3 Enable Siren tamper
4 Enter learn mode (not suitable for first time set-up)
5 Exit learn mode
Exiting setting mode:
Press disarm twice.
(The Keypad LED will now stop flashing.
If not, press disarm twice again).
Press x2
Press
x 5 & 5 x
5
6
7
ENTER ****
To Next Page
Loading...
