8
Programming is now finished and the system is ready to be installed.
This unit is equipped with the latest type of radio
receiver using AM radio technology. If the system is
armed any criminal attempt to interfere with detector
transmissions will trigger an alarm.
If the alarm is frequently triggered by interference there
may be high levels of unusual radio signals in your area.
Some kinds of electronic equipment can generate this
kind of radio interference.
In the unlikely event of you experiencing problems
with interference, it is recommended that you switch
interference detection off.
i
3. Programming the Alarm
4
5
Exiting Learn mode:
• Press the Siren Learn button to exit the learn mode
(The LED 2 will flash once with a single beep to indicate that
normal Siren operation has been resumed.)
a
b
1
2
Test location for radio
signal strength
(2
Enable/disable interference detection:
• Set Dip switch 2 for interference detection.
Programming
dip switches
Learn button
Tamper switch
Power switch
4 x Siren
fixing
screws
LED 1
LED 2
LED 3
Battery
compartment
screws x 4
Unscrew to
open battery
compartment
to remove
battery saver
tab before
first use.
x 1
4
3
2
1
ON
OFF
To Next Page
Loading...
Need help?
General
