EMU00174
Chapter 3
OPERATION
INSTALLATION ........................................3-1
Mounting the outboard motor .................3-2
Clamping the outboard motor.................3-4
BREAKING IN (RUNNING IN)
ENGINE .....................................................3-5
PRE-OPERATION CHECKS ....................3-7
FILLING FUEL AND ENGINE OIL ...........3-8
Filling fuel................................................3-8
Gasoline (petrol) and oil mixing ..............3-9
STARTING ENGINE ...............................3-11
WARMING UP ENGINE..........................3-18
CHECKING POINTS AFTER
STARTING ENGINE ...............................3-19
SHIFTING ................................................3-20
Forward.................................................3-20
Reverse.................................................3-21
STOPPING ENGINE ...............................3-22
TRIMMING OUTBOARD MOTOR..........3-23
Adjusting trim angle ..............................3-24
TILTING UP/DOWN ................................3-26
CRUISING IN SHALLOW WATER ........3-28
CRUISING IN OTHER CONDITIONS.....3-30
Cruising in salt water ............................3-30
Cruising in turbid water.........................3-30
GB
69R-9-71 (GB,F,ES) 3A 3/23/02 2:32 PM Page 2
To Next Page
