4-6
E
EMK21010
Filling Fuel Tank
Fill the fuel tank with fresh fuel and add
one ounce of “Yamaha Fuel Conditioner
and Stabilizer” (Part No. LUB-FUELC-12-
00) to each gallon of fuel.
NOTE:
The use of “Yamaha Fuel Conditioner and
Stabilizer” eliminates the need to drain
the fuel system. Consult your Yamaha
dealer or other qualified mechanic if the
fuel system is to be drained instead.
EMK22211
Flushing Cooling System and Fogging
Engine
Cooling system flushing is essential to
prevent the cooling system from clogging
up with salt, sand, or dirt. In addition, fog-
ging of the engine is mandatory to pre-
vent expensive engine damage due to
rust. Perform the flushing and fogging at
the same time.
1) Remove the cowling.
2) Install the outboard motor on the
water tank, and fill the tank with fresh
water to above the level of the anti-
cavitation plate.
1 Water surface
2 Lowest water level
cC
If the fresh water level is below the level
of the anti-cavitation plate, or if the water
supply is insufficient, engine seizure may
occur.
6L2-9-1H 4 4/20/01 1:49 PM Page 7
To Next Page
Loading...
