EasyManua.ls Logo

Yamaha 40 - Tiller Control Model Starting Procedure

Yamaha 40
232 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-13
GB
501024
N
501023
000976
EMU01497
PROCEDURE FOR TILLER CONTROL
MODEL
4) Place the gear-shift lever in the neu-
tral position.
NOTE:
The start-in-gear protection device pre-
vents the engine from starting except
when in Neutral.
5) Attach the engine stop switch lanyard
to a secure place on your clothing, or
your arm or leg. Then, install the lock
plate on the other end of the lanyard
in the engine stop switch.
w
8 Attach the engine stop switch lanyard
to a secure place on your clothing, your
arm or leg while operating.
8 Do not attach the lanyard to clothing
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
8 Avoid accidentally pulling the lanyard
during normal operation. Loss of
engine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly.
This could cause people and objects in
the boat to be thrown forward.
6) Place the throttle control grip in the
START position.
63B-9-78-A0-3a 2/17/03 4:35 PM Page 30

Other manuals for Yamaha 40

Related product manuals