EasyManua.ls Logo

Yamaha 85A - START-IN-GEAR PROTECTION

Yamaha 85A
223 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-7
GB
NOTE:
At full throttle and under a maximum
boat load, the engine’s rpm should be
within the upper half of the full throttle
operating range, as listed in “SPECIFICA-
TIONS” on page 4-1. Select a propeller
which fulfills this requirement.
If operating under conditions which allow
the engine’s rpm to rise above the maxi-
mum recommended range (such as light
boat loads), reduce the throttle setting to
maintain the rpm in the proper operating
range.
1 Propeller diameter (in inches)
2 Propeller pitch (in inches)
3 Type of propeller (propeller mark)
Refer to the section “CHECKING PRO-
PELLER” for instructions on propeller
removal and installation.
13 x 17 - K
q w e
000933
75/85/115
q
602011
10-3/4x17-G
1 23
55
EMU01208
START-IN-GEAR PROTECTION
Yamaha outboard motors which have the
pictured label 1 affixed to them or Yama-
ha approved remote control units are
equipped with start-in-gear protection
device(s). This feature permits the engine
to be started only when it is Neutral.
Always select Neutral before starting the
engine.
697-9-75 (GB,F,ES)1 5/8/01 2:55 PM Page 20

Table of Contents

Related product manuals