Why Yamaha Outboard Motor gauge operates unstably?
If the gauge operates unstably, it could be because a resistor is not connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs.
How to fix Yamaha Outboard Motor trim gauge showing incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sender could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sender.
Why Yamaha Outboard Motor Speedometer or Comb. Speedometer & Fuel mgt gauge shows incorrect fuel level?
If the speedometer or combination speedometer & fuel management gauge shows an incorrect fuel level, the fuel sensor selection is likely wrong. Set up the fuel sensor to the correct resistance.
What to do if Yamaha 85AET gauge shows “----”?
If the gauge displays '----', it indicates that the digital signal is not being received. Check that the couplers are securely connected and replace any damaged bus wires or hubs.
What causes Yamaha 85AET Outboard Motor fuel management gauge to show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting may be wrong (specifically for SQR Fuel mgt Gauge). Fill the tank with fuel, and set the correct fuel tank capacity.
How to fix Yamaha 85AET tachometer showing incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong (especially for multi-applications). To correct this, push the 'SET' button for 10 seconds to default the engine number, then memorize each engine number again.
Why Yamaha Outboard Motor illumination does not light?
If the illumination does not light, it could be due to a lack of electrical power or a damaged gauge. You should try replacing the fuse, connecting the couplers securely, replacing the damaged wire or hub, or replacing the gauge.
What to do if the Yamaha 85AET gauge display does not wake up?
If the gauge display doesn't wake up, it could be due to a lack of electrical power or a damaged gauge. Try these steps: replace the fuse, securely connect the couplers, replace any damaged wires or hubs, or, if necessary, replace the gauge itself.
Why Yamaha Outboard Motor PTT unit does not hold the outboard motor up?
If your Yamaha Outboard Motor's PTT unit isn't holding the motor up, a possible cause is that the manual valve is opened; check the manual valve. Also, there might not be enough PTT fluid, so ensure you add sufficient fluid. Another reason could be PTT fluid leakage; in this case, check the PTT unit for leakage. Finally, the main valves might not be operating, requiring you to disassemble and inspect the PTT unit.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Step-by-step instructions for safely removing the outboard motor from its shipping crate.
Details on how to correctly position and mount the outboard motor on the boat transom.
Lists specific propeller models and their applications for 2014 models.
Overview of throttle control systems and applicable models for remote controls.
Overview of the multi-function tiller handle and its electrical functions.
Procedures for mounting gauges, including angle and clearance requirements.
Functions and applications of the fuel management gauge.
Representative wiring diagram samples for remote controls and instruments.
Table of common troubles, causes, measures, and notes for digital network gauge systems.
Wiring diagrams for dual station applications with 6Y9 gauges for single, twin, and quad engines.
Details on recommended battery types, charging voltage, and capacity ratings for 4-stroke and 2-stroke engines.
Wiring examples for single and twin engine applications, including isolator-equipped models.
General| Brand | Yamaha |
|---|---|
| Model | 85AET |
| Category | Outboard Motor |
| Language | English |
To Next Page
