En 157
Changing the speaker impedance setting (SPEAKER IMP.)
Change the unit’s speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Turning on/off the remote control sensor
(REMOTE SENSOR)
Turn on/off the remote control sensor on the main unit. While the remote control sensor
is turned off, you cannot control the unit from the remote control.
Settings
Selecting the remote control ID (REMOTE CON AMP)
Change the unit’s remote control ID so that it matches the remote control’s ID (default:
ID1). When using multiple Yamaha AV receivers, you can set each remote control with a
unique remote control ID for its corresponding receiver.
Settings
ID1
, ID2
■ Changing the remote control ID of the remote control
1
To select ID1, hold down the cursor key (e) and SCENE 1 together for 3 seconds.
To select ID2, hold down the cursor key (e) and SCENE 2 together for 3 seconds.
Changing the FM/AM tuning frequency setting
(TUNER FRQ STEP)
(Asia and General models only)
Change the FM/AM tuning frequency setting of the unit depending on your country or
region.
Settings
6 MIN
Select this option when you connect 6-ohm speakers to the unit. You
can also use 4-ohm speakers as the front speakers.
8
MIN
Select this option when you connect 8-ohm or higher speakers to the
unit.
ON
Turns on the remote control sensor.
OFF Turns off the remote control sensor.
SBLRPL SBRSBRPR
SW1
SL
SW2SW
SR
FPL
CLR
FPR
8¬MIN
SPEAKER IMP.
SBLRPL SBRSBRPR
SW1
SL
SW2SW
SR
FPL
CLR
FPR
ON
REMOTE SENSER
FM100/AM10
Select this when you want to adjust the FM frequency by 100-kHz steps
and AM by 10-kHz steps.
FM50/AM9
Select this when you want to adjust the FM frequency by 50-kHz steps
and AM by 9-kHz steps.
SBLRPL SBRSB RPR
SW1
SL
SW2SW
SR
FPL
CLR
FPR
ID1
REMOTE CON AMP
SBLRPL SBRSBRPR
SW1
SL
SW2SW
SR
FPL
CLR
FPR
FM50/AM9
TUNER FRQ STEP
To Next Page
Loading...
Need help?
General
