Need help?Do you have a question about the Yamaha AX-750 and is the answer not in the manual?
General| Input Sensitivity (line) | 150mV |
|---|---|
| Signal-to-Noise Ratio (line) | 110dB |
| Damping factor | 150 |
| Input sensitivity (MM) | 2.5mV |
| Signal to noise ratio (MM) | 90dB |
| Output (line) | 150mV |
| Total Harmonic Distortion (THD) | 0.015% (20Hz-20kHz, 8 ohms) |
| Frequency Response | 20Hz to 20kHz |
| Dimensions | 435 x 151 x 391.5mm |
| Channel separation (line) | 70dB (1kHz) |
| Speaker load impedance | 4Ω to 16Ω |
Instructions for correctly connecting audio components, ensuring proper L/R and +/- connections.
Recommended methods for connecting speaker wires or banana plugs to speaker terminals.
Details on PRE OUT/MAIN IN, REMOTE CONTROL, GND, and AC OUTLET terminals and their uses.
How to choose between speaker systems A, B, or both using the front panel switches.
Guide to selecting MM or MC cartridge type for optimal phono input performance.
Steps to adjust left/right speaker volume balance for sound room correction.
Explanation of the subsonic filter for removing low-frequency rumble from records.
How to adjust bass and treble frequencies for desired sound tonal characteristics.
How to switch between stereo and monaural playback modes.
Compensates for hearing loss at low volumes to maintain full tonal range.
Bypasses tone controls for purer sound; indicator illuminates when active.
Overview of remote control buttons for amplifier and component operations.
Explains controls for selecting input sources and adjusting volume.
Details on controlling connected components like CD players and tape decks.
Instructions for correctly installing batteries in the remote control.
Guidance on when and how to replace batteries in the remote control.
To Next Page
