Yamaha BANSHEE - Page 125

8-24
Assembling and installing the carburetors
Assemble and install both carburetors by the fol-
lowing steps.
1. Install the needle valve and float.
2. Install the float chamber by installing the
screws.
3. Install the carburetor and tighten the joint
screws.
4. Assemble the throttle valve.
5. Install the carburetor cap, and then tighten
it securely to the specified torque.
6. Install the carburetor cap securing plate
by installing the screw.
cC
Be sure to match one of the projections on
the carburetor cap with one of the indents
on the securing plate. If the securing plate
does not match a projection, tighten the
carburetor cap until they align. Do not
loosen the carburetor cap.
7. Tighten the carburetor cap securing plate
screw to the specified torque.
8. Tighten the carburetor joint screws.
1
2
3
4
Carburetor cap tightening torque:
4 Nm (0.4 m0kgf, 2.9 ft0lbf)
Tightening torque:
3.5 Nm (0.35 m0kgf, 2.5 ft0lbf)
1. Carburetor cap securing plate 2. Projection
3. Indent
4. Carburetor cap securing plate screw
5FK-9-17-03 10/3/04 9:36 PM Page 25