Firmware Update Procedure for CD-N500
IMPORTANT NOTICE
Follow the instructions carefully and do not attempt any other procedures not specified in the
instructions provided by Yamaha.
Improperly updated products may cause improper operation, and any parts or service required to
restore proper operation will not be covered under the Yamaha Limited Warranty.
Choose from the following 2 methods to update to the latest firmware.
Click here for Firmware Update Through the Internet
(Connection to the Internet is required)
Click here for Firmware Update by USB
(A USB thumb drive is required)
In case of error, see the Troubleshooting section
[ 1. Firmware Update Through the Internet ]
Requirements:
Your network player is connected to the Internet if you can receive
Internet radio stations. (See ownerʼs manual for details)
STEP 1 Power on and enter SETUP mode
Press SETUP button on the remote control.
STEP 2 Start Update
Using the UP/DOWN buttons, select menu “7 Firmware Update”
and press ENTER button. After that, select “Network” using
LEFT/RIGHT buttons and press Enter button.
When “Press ENTER to start” is displayed, press Enter button again
for starting update.
ENTER
SETUP
LEFT
RIGHT
UP
DOWN
To Next Page
Need help?
General
Weight and Dimensions
