S
sherry28Aug 15, 2025
How to reduce noise from a tuner near my Yamaha CD Player?
- TTina StevensonAug 15, 2025
To reduce noise from a tuner affecting your Yamaha CD Player, move the tuner and the main unit farther apart.
To Next PageTo Next PageHow to reduce noise from a tuner near my Yamaha CD Player?
To reduce noise from a tuner affecting your Yamaha CD Player, move the tuner and the main unit farther apart.
Why is there no sound coming from my Yamaha CDX-397MK2?
If you're not getting any sound from your Yamaha CD Player, there could be a few reasons. First, check the output cable connections to ensure they are properly connected and not defective. Second, make sure your amplifier is set to the correct input selection. Finally, verify that the OUTPUT LEVEL +/– buttons are not set at the minimum; adjust the volume accordingly.
What to do if the remote control for my Yamaha CDX-397MK2 CD Player isn't working?
If the remote control for your Yamaha CD Player isn't working, try these steps: * Replace the batteries with new ones. * Ensure you are within a 6-meter range and 60° radius of the unit. * Check if direct sunlight or strong lighting is interfering with the remote control sensor on the main unit; if so, reposition the main unit.
Why does the sound skip on my Yamaha CDX-397MK2?
If the sound skips on your Yamaha CD Player, it could be due to a couple of reasons. First, the unit might be experiencing vibrations or impacts; try relocating it. Second, the disc might be dirty; clean the disc to see if that resolves the issue.
What to do if my Yamaha CDX-397MK2 won't start playback?
If your Yamaha CD Player won't start playback, consider the following: * Check the disc for damage and replace if necessary. * If there is moisture on the laser pickup, wait 20 to 30 minutes after switching the unit ON before trying again. * Ensure the disc is loaded with the label side up. * Clean the disc. * If using a CD-RW, ensure it is correctly recorded and playable with this unit. * The disc may be a non-standard disc not playable with this unit.
How to stop my Yamaha CDX-397MK2 CD Player from humming?
To stop your Yamaha CD Player from humming, ensure the audio cables are securely connected. If the problem continues, the cables may be defective and need replacement.
What to do if the disc tray on my Yamaha CDX-397MK2 won't close?
If the disc tray on your Yamaha CD Player isn't closing completely, carefully check the tray for any foreign objects that might be obstructing it and remove them.
Why is playback delayed or starting in the wrong place on my Yamaha CDX-397MK2 CD Player?
If playback is delayed or starts at the wrong place on your Yamaha CD Player, the disc may be scratched or damaged. Check the disc carefully and replace it if necessary.
Why is my TV acting strange when I use the Yamaha CDX-397MK2 CD Player remote?
If your TV functions strangely when you use the Yamaha CD Player remote, it might be because the remote is interfering with the TV's remote control sensor. Try relocating the main unit away from the TV or cover the TV’s remote control sensor.
What causes noise from inside the disc tray of my Yamaha CDX-397MK2 CD Player?
Noise from inside the disc tray of your Yamaha CD Player is likely caused by a warped disc. Replace the disc to resolve this issue.
General| Frequency range | 2 - 20000 Hz |
|---|---|
| Signal-to-Noise Ratio (SNR) | 105 dB |
| Total Harmonic Distortion (THD) | 0.003 % |
| CD-RW playback | Yes |
| File type | MP3, WMA |
| Device type | HiFi CD player |
| Product color | Black |
| Dimensions (WxDxH) | 435 x 87 x 287 mm |
Weight and Dimensions| Weight | 3500 g |
|---|
Lists part numbers for mechanical components like front/rear panels and PCB assembly for CDX-397MK2 and CDX-397.
Details supported disc types (Music CD, MP3, WMA) and available finishes (Black, Titanium).
Diagram showing component layout on the Main (1) Printed Circuit Board from the top.
Diagram showing component layout on the Main (2) Printed Circuit Board from the top.
Electrical schematic detailing the main circuit connections and components for the CD player.
