What to do if my Yamaha Generator engine won’t start?
If your Yamaha Generator engine won’t start, make sure fuel is being supplied to the combustion chamber. Check that the fuel cock knob is in the “ON” position and that the fuel line and carburetor are not clogged. If the oil level is low, add engine oil. Also, ensure the engine switch is set to “START”. Finally, remove any carbon or moisture from the spark plug.
Why Yamaha Generator engine won’t start?
The Yamaha Generator engine might not start because no fuel is supplied to the combustion chamber, the fuel line is clogged, or the carburetor is clogged. Also, the oil level might be low, or the spark plug may be dirty with carbon or wet. In rare cases, there is a faulty ignition system, in which case you should consult a Yamaha dealer.
How to fix Yamaha Generator that won’t start?
To fix a Yamaha Generator that won't start, first supply fuel. Then, turn the fuel cock knob to the “ON” position. After that, clean the fuel line and carburetor. Next, add engine oil if the oil level is low and set the engine switch to “START”. Finally, remove carbon or wipe the spark plug dry. If the problem persists, consult a Yamaha dealer, as the ignition system may be faulty.
General| Type | Inverter |
|---|---|
| Maximum AC Output | 6300 watts |
| Rated AC Output | 5500 watts |
| Running Watts | 5500 watts |
| AC Voltage | 120 / 240V |
| AC Frequency | 60 Hz |
| Engine Displacement | 357cc |
| Noise Level | 58-64 dBA |
| Rated AC Output Amps | 45.8 / 22.9 A |
| Engine | OHV, air-cooled, 4-stroke |
| Run Time at 1/4 Load | 13.3 hrs |
| Starting System | Electric |
| DC Output | 12V, 8A |
| Fuel Tank Capacity | 4.5 gallons |
Identifies and describes the various controls and indicators on the generator's panel.
Explains the function and operation of the engine switch.
Details the oil warning light's function and what it indicates.
Describes the AC protector's role in preventing overloads.
Explains the economy control switch for fuel efficiency and noise reduction.
Information on the GFCI receptacle and its safety function.
Guide on selecting the appropriate voltage output (120V/240V or 120V).
Explains how the hour meter tracks generator operating hours.
Describes the power meter's function to show electrical current usage.
Explains the AC pilot light indicating power generation.
Details the overload indicator light and its relation to overload protection.
Instructions on how to remove and secure the fuel tank cap.
Explains the ON/OFF positions of the fuel cock knob.
Guide on connecting the ground terminal for electrical safety.
Explains how to use the caster lock lever to secure the generator.
Instructions and precautions for adding fuel to the generator tank.
Guides on checking and filling the engine oil level.
Procedures for preparing and installing the generator's battery.
Steps to check the fuel level before starting the generator.
Guide to inspect the fuel hose for cracks or damage.
Procedures for checking engine oil level before operation.
How to check for and address abnormalities after use.
Step-by-step guide on how to start the generator engine.
Instructions on how to properly shut down the generator.
How to connect electrical devices to the generator's AC outlets.
A chart outlining maintenance tasks and intervals.
How to inspect, check, and replace the spark plug.
Information on carburetor adjustment, recommending dealer service.
Step-by-step guide for changing the engine oil.
Instructions for cleaning and maintaining the air filter element.
Guide to cleaning and inspecting the muffler screen and spark arrester.
Procedures for cleaning or replacing the fuel tank filter.
Safety precautions and handling for the generator battery.
Instructions for replacing the generator's fuse.
How to test the Ground Fault Circuit Interrupter receptacle.
Steps to drain the fuel tank and carburetor for long-term storage.
Procedures to protect the engine from corrosion during storage.
Recommendations for storing the battery in a cool, dark, and dry place.
Common causes and solutions for the engine failing to start.
Physical dimensions and dry weight of the generator.
Details engine type, displacement, bore, stroke, and fuel type.
AC output, voltage, frequency, rated current, and safety device type.
Voltage and capacity of the generator's battery.
Guidance on recording primary ID and serial numbers for spare parts.
Explains where to find the machine's serial number for identification.
Details the duration of the warranty for EF series generators.
Lists common reasons warranty coverage may be denied.
Exclusions for parts related to normal wear or routine maintenance.
Outlines owner's duties for maintaining warranty coverage.
Warranty coverage for the evaporative emission control system.
Steps required to transfer the remaining warranty to a new owner.
Frequently asked questions regarding warranty terms and coverage.
Information on how to obtain warranty service and assistance.
Instructions for owners to update their contact information for recalls.
To Next Page
