How to enable digital effects on Yamaha EMX512SC?
Make sure the EFFECT knob on each channel is correctly adjusted. Confirm that the internal effector’s ON switch is activated. Also, check that the EFFECT RETURN knobs in the MAIN and MONITOR sections are properly adjusted.
What to do if my Yamaha EMX512SC Music Mixer has no sound?
First, ensure that all microphones, external devices, and speakers are correctly connected. Next, check if the channel LEVEL knobs and the two MASTER knobs are set to appropriate levels. Also, verify that the speaker cables are not shorted. If the problem persists after these checks, it may require professional assistance.
Why is the sound from my Yamaha Music Mixer faint and distorted?
Check that the channel LEVEL knobs and the two MASTER knobs are set appropriately. Verify that the LINE/MIC switches on channels 1 to 4 are set correctly. Ensure that you have not connected to both INPUT A and INPUT B on channels 1 to 4—use only one input per channel. Also, check if the input signal from the connected device is set to an appropriate level.
What to do if Yamaha EMX512SC Music Mixer power suddenly went off?
The EMX unit may overheat if the vents are blocked. Check the vents at the sides and rear of the unit to ensure they are not obstructed. If overheating is the cause, wait for the unit to cool down before turning the power back on.
Why did the sound suddenly stop on my Yamaha Music Mixer?
The EMX unit may overheat if the vents are blocked. Inspect the vents on the sides and rear of the unit. If the unit overheats, it may cut off the output to the internal amp until it cools down.
How to get more forceful sound from Yamaha EMX512SC Music Mixer?
Try turning on the YS Processing switch. Also, adjust the equalizers (HIGH, MID, and LOW knobs) on each channel and fine-tune the graphic equalizers to enhance the sound.
How to make spoken words clearer on Yamaha Music Mixer?
Ensure that the YS Processing switch is turned off. Adjust the equalizers (HIGH, MID, and LOW knobs) on each channel, and also adjust the graphic equalizers to optimize clarity.
How to listen to monitor output on Yamaha EMX512SC?
Connect a powered speaker to the MONITOR OUT jack. Adjust the MONITOR OUT signal using the channel MONITOR knobs and the MONITOR section’s MASTER knob. To send the monitor signal to SPEAKERS jacks B1 and B2, set the POWER AMP switch to the down position (to MAIN(L+R) / MON).
Why FCL lamp is on when there is no howling on Yamaha EMX512SC Music Mixer?
Input of a continuous sound may cause the lamp to come on even in the absence of howling.
General| Channels | 12 |
|---|---|
| Phantom Power | Yes (+48V) |
| Type | Powered Mixer |
| Output Power | 500W + 500W (4 ohms), 350W + 350W (8 ohms) |
| Frequency Response | 20 Hz - 20 kHz |
| Power Output | 500W + 500W/4 ohms, 350W + 350W/8 ohms |
| Built-in Effects | Yes |
| Equalizer | 3-band EQ per channel |
| Weight | 10 kg |
| Outputs - Main | Yes |
| Outputs - Record | Yes |
| Stereo Inputs | 4 |
| Total Harmonic Distortion | 0.3% |
To Next Page
