Need help?Do you have a question about the Yamaha F100 and is the answer not in the manual?
General| Full Throttle RPM Range | 5000 - 6000 rpm |
|---|---|
| Ignition | TCI (Transistor Controlled Ignition) |
| Lubrication | Wet Sump |
| Starting System | Electric |
| Steering | Remote |
| Engine Type | 4-stroke, DOHC, 16-valve |
| Prop Shaft Horsepower | 100 hp |
| Fuel Induction System | EFI (Electronic Fuel Injection) |
| Fuel Type | Regular unleaded gasoline (min 87 octane) |
| Recommended Oil | Yamalube 4M |
| Alternator Output at W.O.T. | 35 Amp |
| Trim & Tilt | Power Trim & Tilt |
| Shaft Length | L: 508 mm (20 in), X: 635 mm (25 in) |
| Exhaust | Through prop hub exhaust |
Provides detailed dimensions for mounting outboard motors on the transom, including various measurements and their definitions.
Provides diagrams for various common remote control configurations and wiring setups for single and twin engines.
Offers comprehensive boat wiring diagrams for single and dual engine installations across various horsepower ranges.
Explains the assembly and parts list for the 701 side mount remote control, suitable for manual start motors.
Covers the assembly and parts list for the 703 standard side mount control box, including various features.
Details the assembly and parts for the 704 single and dual binnacle mount remote controls.
Provides assembly and parts information for the 705 flush side-mount remote control, including push-to-open operation.
Explains how to properly adjust control box settings for smooth and safe operation, including throttle and shift cable adjustments.
Details tachometer types, installation, and calibration for analog and digital meters.
Explains speedometer operation, installation, and calibration, including pitot tube usage and potential inaccuracies.
Covers the installation and adjustment of the 2-wire trim sender and trim gauge for power trim and tilt systems.
Explains the water pressure gauge's function in warning about cooling system issues and its installation with a sensor.
Details the water temperature gauge's use of a cylinder head sensor to indicate cooling water temperature and overheating.
Details the fuel gauge's function in indicating fuel levels and its installation using a fuel tank sensor or existing sender.
Details the installation of the remote control attachment kit for 6/8HP outboards, including parts and procedures.
Provides installation instructions and parts for the 9.9/15 (2-Stroke) remote control attachment kit.
Covers the installation and parts for the F9.9/T9.9 (4-Stroke) remote control attachment kit, including cable adjustments.
Details the installation and parts required for the F15 remote control attachment kit, including reusable parts.
Provides installation instructions and parts for the F25 remote control attachment kit, including removal and assembly steps.
Covers the installation of the 25HP remote control attachment kit for 2-cylinder models, with detailed steps and torque specifications.
Details the installation of the 25/30HP remote control attachment kit for 3-cylinder models, including cable and linkage adjustments.
Discusses Yamaha propeller design, available materials (plastic, aluminum, stainless steel), and series types like Saltwater and Pro Series.
Provides charts for selecting the correct propeller based on engine horsepower, diameter, pitch, and material (aluminum, stainless steel).
Provides detailed instructions for installing the 6X1 Dual Station System, covering various components and procedures.
Offers service information for the 6X1 Dual Station System, including troubleshooting, specifications, and maintenance data.
To Next Page
