Why does my Yamaha Outboard Motor trim gauge always show fully tilted up?
If the trim gauge always shows the fully tilted-up position, the trim sensor signal isn't being received. Connect the pink lead connectors with each other.
Why doesn't my Yamaha F200A boat speed gauge show?
If the boat speed and/or coolant pressure gauge isn't showing, it means the optional sensor hasn't been installed. Install the optional sensor to fix this.
General| Full Throttle RPM Range | 5000 - 6000 rpm |
|---|---|
| Ignition | TCI (Transistor Controlled Ignition) |
| Lubrication | Wet Sump |
| Starting System | Electric |
| Steering | Remote |
| Displacement | 2785cc |
| Fuel Induction System | Electronic Fuel Injection (EFI) |
| Fuel Type | Regular Unleaded (87 octane minimum) |
| Exhaust | Through Propeller |
| Recommended Oil | Yamalube 4M (10W-30) |
| Gear Ratio | 1.86:1 |
| Alternator Output | 50 Amp |
| Trim Method | Power Trim and Tilt |
| Engine Type | 4-Stroke, DOHC, 16-Valve In-Line 4 |
| Max Power Output | 200 hp @ 5500 rpm |
| Cooling System | Thermostatic Controlled Water Cooling |
To Next Page
