Yamaha F200B Owner's Manual

122 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

OWNER’S MANUAL

F200B

LF200B

F225B

LF225B

LIT-18626-05-11

U.S.A.Edition

March 2002–2.0 × 1 CR

Printed in Japan

69J-28199-12

(F200AET, FL200AET, F225AET, FL225AET)

(E)

YAMAHA MOTOR CORPORATION, USA

Printed on recycled paper

Table of Contents

Other manuals for Yamaha F200B

Service Manual579 pages

Rigging Guide329 pages

Questions and Answers:

E
Elizabeth MaysAug 19, 2025
Why does my Yamaha F200B warning buzzer sound?
- E
  Emily BarrAug 20, 2025
  The warning buzzer or indicator lamp might activate due to several reasons: * The cooling system could be clogged, so check the water intake for any restrictions. * The engine oil level might be low; if so, fill the oil tank with the specified engine oil. * The specified engine oil might not be used; in this case, replace the oil with the specified type. * The engine oil might be contaminated or deteriorated; if so, replace it with fresh, specified type. * The load on the boat may be improperly distributed; distribute the load to place the boat on an even plane.
T
Travis MaxwellAug 23, 2025
How to troubleshoot a Yamaha F200B Outboard Motor when the starter won't operate?
- J
  Jenna RiceAug 23, 2025
  If the starter on your Yamaha Outboard Motor won't operate, try these steps: 1. Check the battery condition and use a battery of the recommended capacity if it's weak or low. 2. Tighten battery cables and clean battery terminals if the connections are loose or corroded. 3. Check for a blown fuse in the electric start circuit; find the cause of the overload and repair it, then replace the fuse with one of the correct amperage. 4. Shift to neutral, if the shift lever is in gear.
J
James HarmonAug 26, 2025
What to do if my Yamaha F200B Outboard Motor gauge display does not wake up?
- M
  Michael VasquezAug 26, 2025
  If the gauge display doesn't wake up, it could be due to a lack of electrical power or a damaged gauge. Try these steps: replace the fuse, securely connect the couplers, replace any damaged wires or hubs, or replace the gauge itself.
M
Matthew PerezAug 27, 2025
Why is the illumination not lighting on my Yamaha F200B Outboard Motor gauge?
- M
  Madison HenryAug 27, 2025
  If the illumination isn't lighting, it could be because of a power issue or a damaged gauge. You should try replacing the fuse, ensuring the couplers are securely connected, replacing any damaged wires or hubs, or replacing the gauge.
L
Leonard PhamAug 29, 2025
Why does my Yamaha F200B Outboard Motor fuel management gauge show incorrect fuel consumption?
- P
  pricemiguelAug 30, 2025
  If the fuel management gauge shows incorrect fuel consumption, the engine recognition may be wrong. To resolve this, default the engine number. Then, turn the key switch on in order from the portside engine to re-memorize each engine number.
B
Blake WhiteAug 31, 2025
How to fix a Yamaha Outboard Motor tachometer that shows incorrect engine RPM?
- M
  Melissa LewisAug 31, 2025
  If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong. Push the SET button for 10 seconds to default the engine number, and then memorize each engine number again.
J
Jeremy BlackSep 2, 2025
What to do if my Yamaha Outboard Motor speedometer shows the incorrect fuel level?
- J
  Jennifer ClarkSep 3, 2025
  If the speedometer shows an incorrect fuel level, the fuel sensor selection is likely wrong. You should set up the fuel sensor to the correct resistance.
B
Brooke LawrenceSep 4, 2025
What does it mean when my Yamaha Outboard Motor gauge shows “----”?
- M
  Michael ReyesSep 5, 2025
  If the gauge shows “----”, it indicates that the digital signal is not being received. Make sure the couplers are securely connected and replace any damaged bus wires or hubs.
D
David MunozSep 6, 2025
Why does my Yamaha F200B fuel management gauge show incorrect remaining fuel?
- K
  karinaalexanderSep 6, 2025
  If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting is probably wrong. Fill the tank with fuel, and then set the correct fuel tank capacity.
D
Daniel StephensonSep 8, 2025
Why does my Yamaha Outboard Motor trim gauge show the incorrect position?
- D
  Debbie YoungSep 9, 2025
  If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sensor could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sensor.

Yamaha F200B Specifications

General

Full Throttle RPM Range	5000 - 6000 RPM
Starting System	Electric
Recommended Fuel	Regular Unleaded
Recommended Oil	Yamalube 4M
Steering	Remote
Engine Type	4-Stroke
Displacement	2785 cc
Max Output	200 hp @ 5500 rpm
Bore x Stroke	96 mm x 96.2 mm
Fuel Induction System	Electronic Fuel Injection
Ignition	TCI
Prop Shaft Length	20" / 25"
Alternator Output	50 amps

Related product manuals

Preview: Yamaha F200

Preview: Yamaha F200A

Preview: Yamaha F20A