Operation
39
2. Slightly tilt the outboard motor up to the
desired position using the power trim / tilt
switch.
3. To return the outboard motor to the nor-
mal running position, press the power
trim / tilt switch and slowly tilt the out-
board motor down.
EMU28190
Cruising in other conditions
Cruising in salt water
After operating in salt water, wash out the
cooling water passages with fresh water to
prevent them from becoming clogged with salt
deposits.
NOTE:
For cooling system flushing instructions, see
page 41.
Cruising in turbid water
Yamaha strongly recommends that you use
the optional chromium-plated water pump kit
if you use the outboard motor in turbid (mud-
dy) water conditions.
N
ZMU04588
U69J14E0.book Page 39 Friday, March 12, 2004 10:20 AM
To Next Page
Loading...
