4-9
E
Spark plug
Cleaning/Adjustment/
●●● 4-11
Replacement
Greasing points Greasing ● 4-10
Gear oil Change ●●4-24
Fuel system Inspection ● 4-13
Fuel filter
Inspection/Replacement
●●● 4-14
Fuel tank Cleaning ● 4-25
Idling speed Adjustment ●●4-16
Anode
Inspection/Replacement
11 4-27
Outboard motor exterior Inspection ●● 4-31
Cooling water passages Cleaning ●● 4-5
Propeller Inspection ●● 4-22
Timing belt Inspection 1 4-19
Battery Inspection
● (every
4-28
month)
Power trim and tilt Inspection ●●● 4-21
Ignition timing Inspection/Adjustment 11—
Bolts and nuts Retightening 114-31
Engine oil Change ●●4-17
Oil filter Change 1 —
Valve clearance Inspection/Adjustment 11—
Thermostat Inspection 1 —
Interval
Item
Initial Every
Refer
page
10 hours
50 hours
(3 months)
100 hours
(6 months)
200 hours
(1 year)
EMK30510*
MAINTENANCE CHART
Frequency of maintenance operations may be adjusted according to the operating con-
ditions, but the following table gives general guidelines.
The mark (●) indicates the check-ups which you may carry out yourself.
The mark (1) indicates work to be carried out by your Yamaha dealer.
NOTE:
8 When operating in salt water, turbid or muddy water, the engine should be flushed
with clean water after each use.
8 If leaded gasoline is usually used, engine valves and related parts should be inspect-
ed after every 300 hours of operation in addition to the items on the maintenance
chart above.
62Y-9-1B-4 7/9/02 11:19 Page 10
To Next Page
Loading...
