Operation
35
2. Slightly tilt the outboard motor up to the
desired position using the power trim / tilt
switch.
3. To return the outboard motor to the nor-
mal running position, press the power
trim / tilt switch and slowly tilt the out-
board motor down.
EMU28191
Cruising in other conditions
Cruising in salt water
After operating in salt water, wash out the
cooling water passages with fresh water to
prevent them from becoming clogged with
salt deposits.
NOTE:
For cooling system flushing instructions, see
page 37.
Cruising in turbid water
Yamaha strongly recommends that you use
the optional chromium-plated water pump kit
(not available for some models) if you use
the outboard motor in turbid (muddy) water
conditions.
UP
ZMU01935
UP
DN
UP
ZMU03639
To Next Page
Loading...
