Operation and important riding points
8-2
8
ECA22510
If a warning or indicator light does
not work as described above, see
page 6-4 for the corresponding
warning and indicator light circuit
check.
2. Close the throttle.
3. While applying the front or rear
brake, push the start switch. Re-
lease it when the engine starts.
z If the engine does not start, re-
lease the start switch after 5 sec-
onds. Before pressing the start
switch again, wait 10 seconds to
allow battery voltage to restore.
z When the Stop and Start System
is activated, turning the throttle
grip will start the engine. (See
page 5-1.)
z For (LTF125-I), if the engine will
not start by pushing the start
switch, try using the kickstarter.
ECA11043
For maximum engine life, never ac-
celerate hard when the engine is
cold!
EAU45093
Starting off
1. While pulling the rear brake lever
with your left hand and holding the
grab bar with your right hand,
push the scooter off the center-
stand.
2. Sit astride the seat, and then ad-
just the rear view mirrors.
3. Switch the turn signals on.
4. Check for oncoming traffic, and
then slowly turn the throttle grip
(on the right) in order to take off.
5. Switch the turn signals off.
UB8BE0E0.book Page 2 Wednesday, April 11, 2018 9:35 AM
To Next Page
Loading...
Need help?
General