What to do if MD cannot be removed from Yamaha Minidisc Recorder?
If the MD cannot be removed when partially inserted in your Yamaha Minidisc Recorder, the carriage lock function may have activated. Insert the MD completely, then press the EJECT button to eject it.
Why Yamaha MDX-596 Minidisc Recorder does not respond to operations?
If your Yamaha Minidisc Recorder is not responding, the issue might be with the disc. A dirty or damaged MD can cause this. Try replacing the current disc with a new one. Also, if "UTOC ERR" appears on the display, it indicates the MD is damaged, and you should replace it.
How to eject MD from Yamaha MDX-596 Minidisc Recorder?
If you can't remove the MD from your Yamaha Minidisc Recorder when it's partially inserted, it might be due to the carriage lock function being activated. Fully insert the MD, then press the EJECT button to remove it.
Why does my Yamaha MDX-596 have excessive noise?
If you are experiencing excessive noise with your Yamaha Minidisc Recorder, it could be due to its proximity to other electronic devices. Try placing the unit farther away from the television or other components.
What to do if playback is not possible on Yamaha Minidisc Recorder?
If playback is not possible on your Yamaha Minidisc Recorder, consider the following: 1. If moisture is on the laser pickup, leave the unit switched ON for 20 to 30 minutes to allow the moisture to evaporate. 2. Ensure the power is ON by pressing the POWER button. 3. Make sure the disc is loaded correctly with the label side facing up and the arrow pointing toward the disc insertion slot. 4. If "Blank Disc" appears, insert a recorded MD.
Why Yamaha Minidisc Recorder remote control does not operate?
If your Yamaha Minidisc Recorder's remote control isn't working, try these steps: 1. Replace the batteries. 2. Ensure you're within 6 meters of the unit and within a 30° angle of the sensor. 3. Move the unit away from strong, direct light.
What to do if my Yamaha MDX-596 displays 'U TOC W ERR'?
If your Yamaha Minidisc Recorder displays 'U TOC W ERR', try using another disc, as the disc may have a scratch or other faulty condition.
What to do if my Yamaha Minidisc Recorder displays 'BLANK DISC'?
If your Yamaha Minidisc Recorder displays 'BLANK DISC', verify if the disc is recordable by attempting to record something on it.
Why my Yamaha Minidisc Recorder does not work normally?
If your Yamaha Minidisc Recorder isn't working normally, it might be due to strong external noise (like lightning or static electricity) or a misoperation. Turn the power off, disconnect the AC power from the outlet, wait about 30 seconds, then reconnect and try again.
How to reduce noise from Yamaha Minidisc Recorder?
If your Yamaha Minidisc Recorder is making excessive noise, try moving it further away from your television or other components.
General| Type | MiniDisc Recorder |
|---|---|
| Recording Format | MiniDisc |
| Sampling Frequency | 44.1 kHz |
| Frequency Response | 20 Hz - 20 kHz |
| Harmonic Distortion | < 0.05% |
| Total Harmonic Distortion | < 0.05% |
| Wow and Flutter | Unmeasurable |
| Digital Outputs | Optical |
| Remote Control | Yes |
| Power Consumption | 15W |
| Weight | 3.5 kg |
| Recording System | ATRAC |
| Signal to Noise Ratio | 90 dB |
| Dynamic Range | 90 dB |
| Digital Inputs | Optical, Coaxial |
| Analog Inputs | RCA |
| Analog Outputs | RCA |
To Next Page
