Quick Guide — Advanced Course
Creating a Song on the MOTIF ES
130
Owner’s Manual
Editing a Mixing by using Control Sliders (in the Song mode/Pattern mode)
In the Song/Pattern mode, the four Control Sliders let you independently adjust the levels of the Parts (Voices), letting you
control the overall balance of the Parts.
n Inadvertent use of the sliders may result in no sound. If this occurs, move the sliders upward.
Creating an Arpeggio
In addition using the preset Arpeggios, you can also create your own original Arpeggio data.
Actually, there is no direct operation for recording Arpeggios. First, you have to record a Phrase to a Song or Pattern track.
Then, use the appropriate Song or Pattern Job function to convert the data to Arpeggio data.
■ Determining how Song/Pattern data is converted to an Arpeggio — Convert Type
MIDI sequence data (of Song/Pattern tracks) can be converted to Arpeggio data in one of three ways, according to the
Convert types below. These types can also be selected independently for each destination track — providing enormous
flexibility and performance control.
[SONG] →→
→→
Song selection →→
→→
[MIXING] →→
→→
[EDIT] →→
→→
Part selection →→
→→
[F2] OUTPUT →→
→→
[SF1] VOL/PAN →→
→→
Volume
Normal The Arpeggio is played back using only the played note and its octave notes.
Fixed Playing any note(s) will trigger the same MIDI sequence data.
OrgNotes (Original Notes) Basically same as “Fixed” with the exception that the Arpeggio playback notes differ according to the played chord.
TIP
TIP
Track 1
Track 2
Track 3
Track 4
Track 5
Track 6
Track 7
Track 8
Track 9
Track 10
Track 11
Track 12
Track 13
Track 14
Track 15
Track 16
12
Track 1
Track 2
Track 3
Track 4
Record
User Arpeggio 256
User Arpeggio 001
Song or Pattern
Arpeggio
[SONG] → [JOB] → [F5] TRACK → 07: Put Track To Arp
Record
Record
Record
Convert
You can record MIDI sequence data for
the Arpeggio to any of the tracks. After
recording, select four tracks from all
sixteen and convert them to Arpeggio
data.
Specify the tracks of the source Song or
Pattern. Set unused tracks to “off.”
Set the root note when the
convert type of any track is
set to “OrgNote.”
Specify the destination Arpeggio number.
Specify the source Song/
Pattern number and
measure range.
Select a convert type by track (see below).
After setting the parameters as shown below,
press the [ENTER] button to execute Convert.
Convert the MIDI sequence data (recorded to
the Song or Pattern) as Arpeggio data.
Record the MIDI sequence data to be
used as the basis for base of the Arpeggio
to a Song or Pattern.
To Next Page
Loading...
Need help?
General
