Reference Performance Mode
Performance Edit mode Common Edit
215
Owner’s Manual
[SF1] OUTPUT
Volume Determines the output level of the Audio Input Part.
Settings: 0 ~ 127
Pan Determines the stereo pan position of the Audio Input Part.
Settings: L63 (Left) ~ C (Center) ~ R63 (Right)
RevSend Determines the Send level of the Audio Input Part signal sent to the Reverb effect.
Settings: 0 ~ 127
ChoSend Determines the Send level of the Audio Input Part signal sent to the Chorus effect.
Settings: 0 ~ 127
DryLevel Determines the level of the Audio Input Part which has not been processed with the System Effects (Reverb,
Chorus).
Settings: 0 ~ 127
n For details about Effect connection in the Performance mode, see page 179.
Mono/Stereo Determines the signal configuration for the Audio Input Part, or how the signal or signals are routed (stereo or mono).
Settings: stereo, L mono, R mono, L+R mono
stereo............... Both the L and R channels of the audio input are used.
L (left) mono .... Only the L channel of the audio input is used.
R (right) mono . Only the R channel of the audio input is used.
L+R mono........ The L and R channels of the audio input are mixed and processed in mono.
OutputSel (Output Select) Determines the output jack assignment for the Audio Input Part.
Settings: See page 31.
[SF2] INS TYPE (Insertion Type)
This display is available only when the AD (A/D Part) is set to on from the [F6] EFFECT → [SF2] INS SW display. The
type and connection of the Insertion Effect applied to the A/D Part can be set from this display.
InsEF Connect
(Insertion Effect Connection)
Same as in the CONNECT display in the Voice Edit mode ([VOICE] → [EDIT] → [COMMON] → [F6] EFFECT → [SF1]
CONNECT). Please note that the InsEF Connect cannot be set to “parallel” here.
InsA Ctgry (Insertion A Category)
InsA Type (Insertion A Type)
InsB Ctgry (Insertion B Category)
InsB Type (Insertion B Type)
n Insertion effects can be applied only to the A/D Part, among the Audio Input Parts.
[F6] EFFECT
This menu gives you comprehensive control over the effects. For details about the Effect connections in the Performance mode, see page 179.
[SF1] CONNECT (Connection)
EF PART → PLG-EF
(Plug-in Insertion Effect)
Determines the Part to which the Insertion effect is applied. This parameter is available only when a special Effect
Plug-in board (PLG100-VH) has been installed.
Settings: Part 1~4, PartP2~P3, AD, off
Chorus Ctg (Category),
Chorus Type
Determines the Chorus effect type.
Settings: Refer to the Effect Types list in the separate Data List booklet.
Chorus Return (Level) Determines the Return level of the Chorus Effect.
Settings: 0 ~ 127
Chorus Pan Determines the pan position of the Chorus effect sound.
Settings: L63 (far left) ~ C (center) ~ R63 (far right)
Chorus to Reverb Determines the Send level of the signal sent from the Chorus Effect to the Reverb Effect.
Settings: 0 ~ 127
Reverb Type Determines the Reverb effect type.
Settings: Refer to the Effect Types list in the separate Data List booklet.
Reverb Return Determines the Return level of the Reverb Effect.
Settings: 0 ~ 127
Reverb Pan Determines the pan position of the Reverb effect sound.
Settings: L63 (far left) ~ C (center) ~ R63 (far right)
To Next Page
Loading...
