Basic Operation
Naming
54
Owner’s Manual
■ Basic naming operation
As shown below, you can set the name by repeating the two operations – moving the cursor to the desired location by using the
Cursor button and selecting a character by using the data dial, [INC/YES] button, and [DEC/NO] button.
■ Using the character list
If you find it difficult to select the desired characters with the above method, you may want to use the following method —
selecting the characters from a list.
EXIT ENTER
EXECUTE
DEC/NO INC/YES
DEC/NO INC/YES
Moving the cursor to the desired location on the name Selecting a character at the cursor location
EXIT ENTER
EXECUTE
DEC/NO INC/YES
DEC/NO INC/YES
INFORMATION
INFORMATION INFORMATION
When the cursor is located at the Name, this [LIST]
icon appears and you can call up the Character List
display by holding the [INFORMATION] button.
Release the [INFORMATION] button to return back
to the original display.
Select a character for the cursor location on the name.
Move the cursor to the desired location.
Perform the operations below while holding the [INFORMATION] button.
To Next Page
Loading...
