Instrument and control functions
5-35
1
2
3
4
5
6
7
8
9
10
11
12
3. Tighten the locknut to the specified
torque. NOTICE : Always tighten
the locknut against the adjust-
ing ring, and then tighten the
locknut to the specified
torque.
[ECA22760]
EWA10222
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
Do not tamper with or attempt to
open the cylinder assembly.
Do not subject the shock ab-
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.
Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.
Do not dispose of a damaged or
worn-out shock absorber as-
sembly yourself. Take the shock
absorber assembly to a Yamaha
dealer for any service.
EAU15152
Luggage strap holders
There is a luggage strap holder on each
passenger footrest.
Spring preload:
Minimum (soft):
Distance A = 0.0 mm (0.00 in)
Standard:
Distance A = 2.0 mm (0.08 in)
Maximum (hard):
Distance A = 9.0 mm (0.35 in)
Tightening torque:
Locknut:
25 N·m (2.5 kgf·m, 18 lb·ft)
1. Luggage strap holder
BW8-9-20_1.book 35 ページ ２０１６年１２月１３日 火曜日 午前１１時１８分
To Next Page