Yamaha MT09 2020 - Page 32

Instrument and control functions
5-11
1
2
3
4
5
6
7
8
9
10
11
12
vehicle has traveled 1 km (0.6 mi).
Coolant temperature
This display shows the coolant temper-
ature from 104 F to 242 F in 1 F in-
crements.
If the message “HI” flashes, stop the
vehicle, then stop the engine, and let
the engine cool. (See page 8-38.)
TIP
 When the coolant temperature is
below 103 F, “Lo” will be dis-
played.
 The coolant temperature varies
with changes in the weather and
engine load.
Air intake temperature
The air intake temperature display indi-
cates the temperature of the air drawn
into the air filter case.
This display shows the air intake tem-
perature from 14 F to 210 F in 1 F in-
crements.
TIP
 14 F will be displayed even if the
actual temperature is lower.
 The air intake temperature may
vary from the actual ambient tem-
perature.
Brightness control mode
The brightness of the multi-function
meter unit panel can be adjusted.
To adjust the brightness
1. Turn the key to “OFF”.
2. While pushing the “SELECT” but-
ton, turn the key to “ON” and con-
tinue pushing the button until the
display switches to the brightness
control mode.
3. Push the “RESET” button to set
the brightness level.
4. Push the “SELECT” button to con-
firm the selected brightness level
and exit the brightness control
mode.
1. Coolant temperature display
1
1. Air intake temperature display
1
1. Brightness level display
1
BS2-9-13.book 11 ページ ２０１９年７月２５日 木曜日 午前１１時１分