Yamaha MT09 2020 - Supporting the Motorcycle

Periodic maintenance and adjustment
8-35
1
2
3
4
5
6
7
8
9
10
11
12
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by turning it clockwise.
6. Install the turn signal light unit by
installing the screw. NOTICE: Do
not overtighten the screw, oth-
erwise the lens may break.
[ECA11192]
EAU67131
Supporting the motorcycle
Since this model is not equipped with a
centerstand, use maintenance stands
when removing the front or rear wheel
or when performing other maintenance
that requires the motorcycle to stand up
right.
Check that the motorcycle is in a stable
and level position before starting any
maintenance.
1. Turn signal light bulb socket
1. Turn signal light bulb
1
1
1. Maintenance stand (example)
1
BS2-9-13.book 35 ページ ２０１９年７月２５日 木曜日 午前１１時１分