Yamaha MX-50 - Precautions and Safety; Location and Environmental Considerations; Ventilation and Airflow Management; Handling and Power Cord Safety

Keep this manual in a safe place for future
reference.
Avoid placing your MX-50 in direct sunlight
or close to a source of heat Also avoid io-
cations in which the device is likely to be
subjected to excessive dust, cold or mois-
ture.
The openings on the cabinet ensure the
ventilation of the amplifier. If these openings
are obstructed, the temperature inside the
cabinet will rise rapidly and eventually
damage the circuits. Therefore, avoid plac-
ing objects against these openings and do
not install your amplifier in a place such that
the flow of air through the ventilation
openings could be impeded.
ASO
Së Power cord
When removing the power plug from the wall
outlet, always pul! directly on the plug. Never
yank the cord as this may result in damage
to the cord and possibly a short-circuit.
if you do not intend to use this unit for an
extended period of time, it is advisable to
unplug the power cord.
= Switches and knobs
Avoid applying excessive force to the
switches and knobs. |
Relocation
Before moving your amplifier, be sure to
unplug the power cord and remove all other
connecting cables.
KH Troubleshooting Chart
Consult the Troubleshooting Chart for advice
on the common operation errors before
concluding that your amplifier is faulty.
BW Servicing
Do not open the cabinet or attempt to make
repairs by yourself, as this may aggravate
the damage and expose you to an electrical
shock.
Object and liquid entry
See to it that foreign objects or spilled liquids
do not enter inside the cabinet. Should this
case arise, consult your YAMAHA dealer.
Wipe off dust with a dry soft cloth. To remove
dirt or fingermarks, use a soft damp cloth
then dry immediately with a clean cloth. Do
not use alcohol, thinners or other chemical
solvents since they may damage the finish
or remove the panei lettering.
Do not use any aerosol sprays near this unit
as these products can easily get into the unit
and damage the circuitry.
Special instructions
for the U.K.
THE WIRES IN THE MAINS LEAD ARE
COLOURED IN ACCORDANCE WITH THE
FOLLOWING CODE: |
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains
lead of this apparatus may not correspon
with the coloured markings identifying th
terminals in your plug, proceed as follow:
The wire which is coloured BLUE must b
connected to the terminal which is marke
with the letter N or coloured BLACK. Th:
wire which is coloured BROWN must be
connected to the terminal which is marke
with the letter L or coloured RED.