Yamaha MX-800/U - Page 4

15. Damage Requiring Service — The ap-
pliance should be serviced by qualified ser-
vice personnel when:
A.The power-supply cord or the plug has
been damaged; or
B. Objects have fallen, or liquid has been
spilled into the appliance; or
C.The appliance has been exposed to rain;
or
D. The appliance does not appear to operate
normally or exhibits a marked change in
performance; or
E. The appliance has been dropped, or the
cabinet damaged. |
1 6. Servicing — The user should not attempt
to service the appliance beyond those means
described in the operating instructions. All
other servicing should be referred to quali-
fied service personnel. |
T7.Grounding or Polarization — The pre-
cautions that should be taken so that the
grounding or polarization of an appliance is
not defeated.
18. speaker Connection — To reduce the
risk of shock or fire and prevent short circuits,
strictly follow the instructions for connecting `
speakers on p. 6.
1 LOCATION
Install this unit in a cool, dry, clean place -
away from windows (direct sunlight), heat
sources, excessive vibration, dust, moisture
or cold. Avoid sources of hum such as
transformers, motors, etc..
Turn the unit off and disconnect it when
moving it.
2 VENTILATION
Do not place records or other objects that
block ventilation on top of the amplifier as
this will cause its internal temperature to rise
and may result in damage.
3 HANDLING
Do not use force on controls, terminals or
cords. Remove plugs by gripping them di-
rectly, not by pulling the cord.
4 CLEANING
Wipe the exterior with a soft, dry cloth. Never
use chemical solvents, as this might damage
the finish.
H MODEL VERSIONS
The illustrations on the right show the rea
panels of the three types of MX-800/U mo-
dels. Note that the Australian model has!
AC convenience outlet, while the general
model is equipped with a selector for volta,
conversion.
Ë VOLTAGE SELECTOR
(General Model only)
This must be set to your local voltage BE-
FORE connecting the amplifier to a wall
socket. To do so, rotate the selector with <
screwdriver until the correct voltage value
(110/120 or 220/240) is visible.
VOLTAGE SELECTOR