To Next PageTo Next PageWhy do my Yamaha NS-P300 Home Cinema speakers have no sound?
If your Yamaha Home Cinema speakers aren't producing sound, first ensure that the VOLUME control isn't set to 0; if it is, turn the VOLUME control to the right. Also, check that the speaker cords are securely connected; if not, connect them securely.
What to do if my Yamaha Home Cinema speakers won't turn on?
If power isn't being supplied to your Yamaha Home Cinema speakers even when the POWER switch is ON, the power plug might not be securely connected. Ensure it is connected securely.
How to fix low sound level on Yamaha NS-P300?
If the sound level from your Yamaha Home Cinema speakers is too low, there could be several reasons: * Speaker cords may be connected incorrectly. Ensure they are connected correctly: L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. * A source sound with few bass frequencies may be playing. Try playing a source sound with bass frequencies or set the HIGH CUT switch to the “HIGH” position. * Standing waves might be influencing the sound. Try re-positioning the subwoofer or disrupting parallel surfaces by placing bookshelves along the walls.
Why my Yamaha NS-P300 won't turn on automatically?
If your Yamaha Home Cinema speakers won't turn on automatically, consider these potential causes: * The POWER switch may be in the OFF position. Ensure it is set to the ON position. * The AUTO STANDBY switch could be set to the OFF position. Set the AUTO STANDBY switch to the “HIGH” or “LOW” position. * The level of input signal might be too low. Try setting the AUTO STANDBY switch to the “HIGH” position.
What to do if Yamaha NS-P300 turn into standby mode unexpectedly?
If your Yamaha Home Cinema speakers unexpectedly enter standby mode, the level of the input signal might be too low. Try setting the AUTO STANDBY switch to the “HIGH” position.
Why do my Yamaha Home Cinema speakers turn on unexpectedly?
If your Yamaha Home Cinema speakers are turning on unexpectedly, it could be due to noise generated from external equipment. Try moving the unit farther away from such equipment and/or changing the position of connected speaker cables. Alternatively, set the AUTO STANDBY switch to the “OFF” position.
General| Type | Home Cinema Speaker System |
|---|---|
| Configuration | 5.1 |
| Impedance | 6 ohms |
| Power Handling (Subwoofer) | 50 W |
| Magnet Shielding | Yes |
How to connect speakers to amplifier terminals.
Connecting subwoofer via speaker or line outputs.
Specific connection setup for single main speaker outputs.
Connecting subwoofer using line output (pin jack) terminals.
Explanation of subwoofer controls and their operation.
