Why scene data cannot be stored on Yamaha Recording Equipment?
If scene data cannot be stored on your Yamaha Recording Equipment, check if memory protect is ON. Also, note that you cannot store scene data to Scene “0.”
What to do if a pair of stereo channels does not sound in stereo on Yamaha O2R?
If a pair of stereo channels on your Yamaha Recording Equipment does not sound in stereo, check if the pan setting is correct.
What to do if the volume level of certain channels goes up and down on Yamaha Recording Equipment?
If the volume level of certain channels on your Yamaha Recording Equipment goes up and down, verify if the dynamics processor ducking is set for those channels.
Why MIDI data cannot be transmitted or received on Yamaha O2R Recording Equipment?
If MIDI data is not being transmitted or received by your Yamaha Recording Equipment, check that the MIDI transmit channel matches the receive channel and that the switch for the item to be transmitted/received (Program Change, Parameter Change) is turned on.
How to turn on Yamaha O2R?
If your Yamaha Recording Equipment isn't powering on, make sure the power cord is correctly plugged into an AC outlet and that the POWER switch is turned ON.
Why is the volume level very low on my Yamaha O2R Recording Equipment?
If the volume level from your Yamaha Recording Equipment is very low, consider the following: * Check if the PAD switch and GAIN volume control are correctly set. * Ensure the input fader is raised sufficiently. * Verify the gain in the equalizer section isn't set too low. * Confirm the threshold and ratio settings for the dynamics processor are correctly configured. * Check that the [DIM] key in the C-R monitor section is OFF.
Why is the sound distorted on my Yamaha Recording Equipment?
If the sound from your Yamaha Recording Equipment is distorted, check these: * Ensure the PAD switch and GAIN volume control are properly set. * Verify the input fader isn't raised too high. * Check that the stereo output fader isn't raised too high. * Confirm the gain in the equalizer section isn't set too high.
General| Type | Digital Mixing Console |
|---|---|
| Sampling Rate | 44.1kHz, 48kHz |
| EQ Bands | 4-band Parametric EQ per channel |
| Aux Sends | 8 |
| Display | LCD |
| Faders | 100mm Motorized Faders |
| Bus Structure | 8 Bus |
| Bit Depth | 20-bit |
| Inputs - Mic Preamps | 16 x XLR |
| Inputs - Line | 16 |
| Inputs - Other | AES/EBU, S/PDIF |
| Outputs | 16 |
| Outputs - Main | 2 |
| Outputs - Other | 2 Stereo |
| MIDI I/O | In/Out/Thru |
| Digital I/O | ADAT optical, TDIF |
| Word Clock | In/Out |
| Dynamic Processors | Compressor, Gate per channel |
| Effects | 2 Internal Effects Processors |
| Analog I/O | 16 inputs, 16 outputs |
To Next Page
