What to do if TEMP indicator lights on Yamaha P1600?
If the TEMP indicator lights up on your Yamaha Amplifier, it means the heat sink temperature has exceeded 85°C. Check the ventilation slots and improve the airflow around the amplifier to resolve this issue.
General| Signal to Noise Ratio | 100 dB |
|---|---|
| Power Consumption | 500W |
| Weight | 15 kg |
| Power Output (8 ohms) | 200W per channel |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion | 0.1% |
| Input Sensitivity | 1.23V |
| Damping Factor | 200 |
| Input Impedance | 10k ohms |
| Cooling System | Forced air |
Explains STEREO, PARALLEL, and BRIDGE operating modes for the amplifier.
Specifies minimum speaker impedance for STEREO, PARALLEL, and BRIDGE modes.
Guidelines for mounting amplifiers in EIA standard racks, emphasizing ventilation.
Procedures for mounting four or fewer amps in an open-backed rack.
Instructions for mounting five or more amps, or when rack backs are not open.
Ensures proper ventilation when mounting amplifiers in portable racks.
Advice on positioning the amplifier case to avoid blocking airflow paths.
Technical data including power output, frequency response, impedance, and weight.
Illustrates the internal signal flow and component connections of the amplifier.
Provides physical dimensions of the amplifier unit in millimeters.
Charts showing power consumption versus output power for different models.
Lists common indicator lights, probable causes, remedies, and protection circuit actions.
To Next Page
