Styles (Auto Accompaniment) and Tabla/Tanpura patterns
PSR-I455 Owner’s Manual
43
Reference
Setting the Split Point
The point on the keyboard that separates the left-hand
range and the right-hand range of the keyboard is
called the “Split Point.”
When a Style is selected and ACMP is on, the notes
played to the left of the Split Point are used to specify
the chord for Style playback. When the Split function
is on, the notes played to the left of the Split Point are
used to play the Split Voice.
The initial default Split Point is key number 54 (the
F#2 key), but you can change it to another key.
1
Press the [FUNCTION] button.
2
Use the CATEGORY [+] and [-] buttons to
call up “SplitPnt” (Function 007).
You can call up this display also by pressing the
[STYLE] then holding the [ACMP] button for lon-
ger than a second.
3
Rotate the dial to set the Split Point
between 036 (C1) and 096 (C6).
Playing Chords Without Style
Playback
If you press the [STYLE] button, press the [ACMP
ON/OFF] button to turn ACMP on (the ACMP ON
icon appears), and play the chord in the Left hand
range of the keyboard (with SYNC START off), the
chord sound will be heard without Style playback.
This is referred to as “Stop Accompaniment.” The
specified chord will be shown in the display, and
affects the Harmony function (page 19).
• The Split Point set here is applied common to the Style
and Voice.
• During the Lesson playback, the Split Point cannot be
changed.
Split Point (54: F#2)
Split voice
Main voice
Appears when auto accompaniment is on
Accompani-
ment range
To Next Page
Loading...
Need help?
General
