PSR-OR700 Installation Procedure
Caution: Do not turn off the power or remove the USB flash memory during this operation.
Confirming the version number
1)Turn on the power of the instrument and wait until the main display appears.
2)Press the [FUNCTION] button, then select [UTILITY] → [OWNER] tab.
3)Press the [7▲] or [8▲] button.
4)Check the version number to proceed with the upgrade.
☆ version 1.04 or earlier ; Go on to step1.
☆ version 1.05 or later ; Skip step1-3 and Go on to stepA.
Boot Program Installation
1
Downloading the boot program
1) Download the Zip file.
2) Extract the two files included in the Zip file.
3) Insert the USB flash memory into your computer.
4) Copy the extracted files into the root directory of the USB flash memory.
2
Connecting the USB flash memory
Insert the USB flash memory containing the appropriate
program to the USB TO DEVICE terminal on the instrument.
Caution: Make sure that the USB flash memory is connected properly to the terminal.
Do not try to force an incorrect connection; doing so may damage the terminal.
3
Installing the boot program
Simultaneously hold down the [PLAY/STOP] button on the panel and turn on the power.
Keep holding down the [PLAY/STOP] button until the following display is shown.
Note : Please confirm that the System Booter shown as『ver.1.00』.
To Next Page
Need help?
General
