1
4
2
3
Press the [START/STOP] button to start installation.
Go on to step 4. (Executing the installation).
Press the [BREAK] button to delete the data the upgrade
data in the USB device.
Go on to step 5. (Deleting the upgrade data).
Installation Procedure
Connecting the USB device
Installing the upgrade program
Caution: Make sure that the USB device is connected properly to the
terminal. Do not try to force an incorrect connection; doing so
may damage the terminal.
Caution: Do not turn off the power or remove the USB media during this operation.
1) Download the Zip file.
2) Extract the six files included in the Zip file.
3) Insert the USB device into your computer.
4) Copy the extracted files into the root directory of the USB device.
Connect the USB device containing the appropriate upgrade data
to the USB TO DEVICE terminal on the instrument.
Simultaneously hold down the [START/STOP] button in the STYLE CONTROL section and turn on
the power.
Keep holding down the [START/STOP] button until the following display is shown.
After a few moments, the following display appears.
Press [START/STOP] button to start the
installation.
When the installation is completed, the
following display appears.
Turn off the power switch on the instrument.
Downloading the firmware
Executing the installation
To Next Page
Need help?
General
