4-4
EBU00053
Handlebar switches
1. Light switch “OFF/ / ”
2. Engine stop switch “ / ”
3. Start switch “ ”
EBU01009
Light switch “OFF/ / ”
Turn the switch to the “ ” position to switch
on the low beam and the taillight.
Turn the switch to the “ ” position to switch
on the high beam and the taillight.
Turn the switch to the “OFF” position to switch
off the headlights and the taillight.
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
_
EBU00849
Engine stop switch “ / ”
Make sure that the engine stop switch is in the
“ ” position. The engine stop switch controls
ignition and can be used at all times to stop
the engine, especially in an emergency. The
engine will not start or run when the engine
stop switch is turned to “ ”.
To Next Page
Loading...
Need help?
General
