To Next PageTo Next PageWhat to do if my Yamaha Stereo Receiver has no sound?
First, ensure the output cords are correctly connected; if the problem persists, the cords might be defective. Also, make sure the appropriate input selector button is pressed, corresponding to your input source.
What to do if my Yamaha Stereo Receiver fails to turn on?
Make sure the power cord is firmly plugged into the outlet.
Why does the sound suddenly go off on my Yamaha Stereo Receiver?
The protection circuit may have activated due to a short circuit or similar issue. Try turning the Yamaha Stereo Receiver off and then on again to reset the protection circuit.
Why is FM stereo reception noisy on my Yamaha Stereo Receiver?
Noisy FM stereo reception can occur when the transmitter is too far away or the antenna input is poor. Check the antenna connections and consider using a multiple element FM antenna to improve reception.
What to do if my Yamaha Stereo Receiver only outputs sound from one speaker?
Check the BALANCE control and adjust it to the appropriate position. Also, ensure the speaker cords are correctly connected; if the problem continues, the cables may be defective.
What to do if my Yamaha Stereo Receiver's remote control doesn't work?
Ensure that direct sunlight or strong lighting isn't hitting the remote control sensor on the main unit; if so, change the unit's position. Also, replace the remote control batteries with new ones, as weak batteries can cause this issue.
Why does my Yamaha Stereo Receiver sound hum?
First, check and firmly connect the audio plugs. If the issue continues, the cord may be defective. Also, ensure there is a GND connection between the turntable and the Yamaha unit if you're using a turntable.
What causes distortion and clear reception issues on my Yamaha Stereo Receiver, even with a good FM antenna?
This issue may be due to multipath interference. Try adjusting the antenna placement to minimize this interference.
What to do if a desired station cannot be tuned in with Auto tuning on my Yamaha Stereo Receiver?
If a station is too weak to be tuned in automatically, switch to Manual tuning mode. Consider using a high-quality directional FM antenna for better reception.
What to do if my Yamaha Stereo Receiver has continuous crackling and hissing noises?
These noises often result from electrical equipment like lightning, fluorescent lamps, motors, or thermostats. Using an outdoor antenna and a ground wire may help reduce these noises, but complete elimination is difficult.
General| Frequency response | 10 Hz-100 kHz (+0 dB, -3 dB) |
|---|---|
| Total harmonic distortion | 0.019% (20 Hz-20 kHz, 8 ohms) |
| Weight | 10.3kg |
| Tuning range | FM |
| Signal to noise ratio | 100 dB (line) |
| Channel separation | 50 dB (1 kHz) |
| Signal-to-Noise Ratio | 100 dB (line) |
How to connect FM and AM antennas to the unit.
Instructions for connecting the AM loop antenna.
Guide on selecting and playing audio sources.
Procedure for saving favorite radio stations.
How to access stored radio stations.
How the unit automatically stores strong FM stations.
Accessing stations found via automatic tuning.
Key functions for controlling the receiver with the remote.
How the remote controls other Yamaha components.
