Need help?Do you have a question about the Yamaha RX-A830 and is the answer not in the manual?
General| Receiver type | - |
|---|---|
| Pre-out channels | 7.2 |
| Audio output channels | 7.2 channels |
| Audio A/D Converter (ADC) | 24-bit/192kHz |
| Dynamic power per channel (4 Ohm) | 210 W |
| Dynamic power per channel (8 Ohm) | 140 W |
| Power output per channel (1KHz@8 Ohm) | 160 W |
| Power output per channel (20-20KHz@8 Ohm) | 100 W |
| HDMI in | 8 |
| Remote (IR) input | 1 |
| Composite video in | 5 |
| Digital audio optical in | 2 |
| Component video (YPbPr/YCbCr) in | 3 |
| Digital audio optical out | 0 |
| 12V trigger | Yes |
| Connectivity technology | Wired |
| AM band range | 530 - 1710 kHz |
| FM band range | 87.5 - 107.9 MHz |
| Supported radio bands | AM, FM |
| Product color | Black |
| Audio decoders | Dolby Digital Plus, Dolby Pro Logic IIx, Dolby TrueHD, DTS-HD Master Audio |
| Volume control | Rotary |
| Power consumption (standby) | 0.15 W |
Weight and Dimensions| Depth | 369 mm |
|---|---|
| Width | 435 mm |
| Height | 171 mm |
| Weight | 10500 g |
Lists supplied items such as remote, batteries, antennas, CD-ROM, and YPAO microphone.
Details essential cables like speaker, HDMI, audio, and optical cables not included with the product.
Illustrates optimal speaker arrangement for a 5.1 surround sound setup, with angle references.
Illustrates optimal speaker arrangement for a 7.1 surround sound setup, including back speakers.
Guides on preparing speaker wires and connecting them using bare wires or banana plugs securely.
Step-by-step instructions for connecting front and center speakers to the receiver's terminals.
Instructions for connecting surround and surround back speakers for 5.1 and 7.1 channel systems.
Details on connecting the powered subwoofer to the receiver's pre-out jack for bass output.
Guides for connecting BD/DVD players and TVs via HDMI and optical cables for optimal signal.
Instructions for powering on connected devices and setting the correct TV input for audio/video.
Step to connect the YPAO microphone to the receiver's front panel jack for calibration.
Instructions to start the automatic speaker setup measurement process using the remote.
Guides on how to save or cancel the YPAO measurement data after completion.
Provides steps to resolve the 'W-1:Out of Phase' warning message during YPAO calibration.
Steps to select the HDMI input and initiate playback on the connected BD/DVD player.
Guides on selecting the STRAIGHT sound mode and adjusting the listening volume.
To Next Page
